ADAPTIVE POWER CONTROL OF THE CUTTING PROCESS ON ABRASIVE CUTTING MACHINES WITH A SWINGING SPINDLE HEAD

Authors

  • Nikolai Andreevich Starovoitov Gomel State Technical University named after P.O. Sukhoi

DOI:

https://doi.org/10.36773/1818-1112-2023-130-1-109-112

Keywords:

abrasive cutting wheel, grinding coefficient, adaptive control, cutting power

Abstract

The results of experimental studies of increasing the productivity of abrasive cutting machines with maintaining a constant cutting speed and adaptive power control of the cutting process of round profile blanks are presented. It has been found that maintaining a constant cutting speed during wear of the abrasive-cutting wheel and maintaining a constant cutting power by changing the feed during the cutting of round blanks leads to an increase in machine productivity by an average of 1.38 times compared to the process with a constant feed rate.

Author Biography

Nikolai Andreevich Starovoitov, Gomel State Technical University named after P.O. Sukhoi

Ph.D in Engineering, Associate Professor of the Department of Engineering Technology, Gomel State Technical University, Gomel, Republic of Belarus.

Downloads

Published

2023-03-24

How to Cite

(1)
Starovoitov, N. A. ADAPTIVE POWER CONTROL OF THE CUTTING PROCESS ON ABRASIVE CUTTING MACHINES WITH A SWINGING SPINDLE HEAD. Вестник БрГТУ 2023, 109-112.

Issue

No. 1(130) (2023): Vestnik of Brest State Technical University

Section

Mechanical Engineering

License

Copyright (c) 2023 Brest State Technical University

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

The work is provided under the terms of Creative Commons public license Attribution-NonCommercial 4.0 International (CC BY-NC 4.0). This license allows an unlimited number of persons to reproduce and share the Licensed Material in all media and formats. Any use of the Licensed Material shall contain an identification of its Creator(s) and must be for non-commercial purposes only. Users may not prevent other individuals from taking any actions allowed by the license.